WiFi.setDNS()
出自YFRobotwiki
|
setDNS()
描述 WiFi.setDNS() allows you to configure the DNS (Domain Name System) server.
WiFi.setDNS(dns_server1) WiFi.setDNS(dns_server1, dns_server2)
dns_server1: the IP address of the primary DNS server dns_server2: the IP address of the secondary DNS server
Nothing
This example shows how to set the Google DNS (8.8.8.8). You can set it as an object IPAddress.
#include <SPI.h>
#include <WiFi.h>
// the IP address for the shield:
IPAddress dns(8, 8, 8, 8); //Google dns
char ssid[] = "yourNetwork"; // your network SSID (name)
char pass[] = "secretPassword"; // your network password (use for WPA, or use as key for WEP)
int status = WL_IDLE_STATUS;
void setup()
{
// Initialize serial and wait for port to open:
Serial.begin(9600);
while (!Serial) {
; // wait for serial port to connect. Needed for Leonardo only
}
// check for the presence of the shield:
if (WiFi.status() == WL_NO_SHIELD) {
Serial.println("WiFi shield not present");
while(true); // don't continue
}
// attempt to connect to Wifi network:
while ( status != WL_CONNECTED) {
Serial.print("Attempting to connect to SSID: ");
Serial.println(ssid);
// Connect to WPA/WPA2 network. Change this line if using open or WEP network:
status = WiFi.begin(ssid, pass);
// wait 10 seconds for connection:
delay(10000);
}
// print your WiFi shield's IP address:
WiFi.setDNS(dns);
Serial.print("Dns configured.");
}
void loop () {
}
|
更多建議和問題歡迎反饋至 YFRobot論壇
